Hunter 23949 48 Forest Hill User Manual download pdf (Page 10)

42693-01 • 05/14/10 • Hunter Fan Company

5-1. IMPORTANT! Before you change the Jumper

settings, make sure the battery is not connected

to the transmitter. Change the position of the

jumpers in the transmitter and the DIP switches

in the receiver. Be sure the position of the jumper

in the transmitter matches the position of the DIP

switches in the receiver. If they don’t match, the

controller will not function. For instructions on how

to set the jumpers, read the box below.

5-2. Install the included 12-volt battery into the

transmitter.

Setting DIP switches and Jumpers

When two or more fans are located near each other, you

may desire to have the receiver/transmitter for each fan

set to a diﬀerent code, so that the operation of one fan

does not aﬀect the operation of the other fans.

e DIP switches for the receiver are located on the ﬂat

surface of the receiver. e Jumpers for the transmitter

are in the the battery compartment.

CAUTION: e remote control device complies with part 15 of

the FCC rules. Changes or modiﬁcations not expressly approved

by Hunter Fan Company could void your authority to operate this

equipment.

Operation is subject to the following two conditions:

1. is device may not cause harmful interference.

2. is device must accept any interference received, including

interference that may cause undesired operation.

Note: Use with a fan that incorporates an air gap switch (normal on-

oﬀ wall switch).

WARNING: Maximum fan load is 1 Amp; maximum lamp is 300

Watts. Do not use any speed control with this product.

You must now set the jumpers in the remote

transmitter and DIP switches in the receiver so that

they match.

4 3 2 1

4 = off (apagado)

3 = on (encendido)

2 = on (encendido)

1 = on (encendido)

4 = off (apagado)

3 = on (encendido)

2 = off (apagado)

1 = on (encendido)

Example Jumpers Settings

Receiver 1

Receiver 2

Transmitter 2Transmitter 1

4 3 2 1

4 = off (apagado)

3 = on (encendido)

2 = on (encendido)

1 = on (encendido)

4 = off (apagado)

3 =

on (encendido)

2 =

off (apagado)

1 = on (encendido)

Dip Switches

Set to 01110

Dip Switches

Set to 01001

Dip Switches

Set to 01110

Dip Switches

Set to 01001

Receiver 2Receiver 2

Example DIP Switch Settings

DIP Switches

Set to 0111

DIP Switches

Set to 0100

DIP Switches

Set to 0100

DIP Switches

Set to 0111

Transmitter 1 Transmitter 2

Receiver DIP

switches

Remote

Transmitter

Jumper Switches

5 • Setting the Remote Transmitter and Receiver

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Comments to this Manuals

No comments

Hunter 23949 48 Forest Hill User Manual Page 10

Comments to this Manuals

Related products and manuals for Fans Hunter 23949 48 Forest Hill