Hunter 22555 10 Opal Glass Schoolhouse Globe User Manual download pdf (Page 3)

Installing the Light Kit on Fans with Removable Switch Housings

1. Unscrew the three screws from the upper switch housing. Disconnect

the 9-pin plug connectors. Remove the lower switch housing.

2. Push the plug button from inside the lower switch housing to remove

the plug button and switch housing cap. Unscrew the two attachment screws on the

bottom of the switch housing.

NOTE: Save the plug button and switch housing cap should you choose to remove

the light ﬁxture in the future.

3. Feed the two wires from the light kit up through the center hole in the lower switch

housing.

CAUTION: If your fan is operated by remote control, take care not to damage

the small components on the circuit board inside the housing.

Align the keyholes of the light kit and the screw holes of the lower switch housing.

Install the nut and washer onto the threaded rod from the light kit.

Finish attaching the light kit to the lower switch housing. Use the two attachment

screws removed from the lower switch housing and the lock washers on the red

tag. Partially install the screws into the light kit and the housing. Rotate the housing

counterclockwise until the screws are locked into the narrow ends of the keyhole

slots. Securely tighten the two screws.

WARNING: Improper installation could cause the light ﬁxture to fall, or result

in electrical shock or personal injury.

4. Remove the wire nuts from the two wires in the switch housing labeled “Connect

Light Here” or “For Light Use.”

Connect the black/white striped wire from the switch housing to the black wire from

the light kit. Connect the white wire from the switch housing to the white wire from

the light kit. Secure all wire connections using wire nuts.

To connect the wires, hold the bare metal leads together and place a wire nut over

them, then twist the wire nut clockwise until tight.

CAUTION: Be sure no bare metal

wires or wire strands are visible after

making the connections.

5. Reconnect the 9-pin plug connector.

6. Install screws to reattach the lower

switch housing to the upper switch

housing.

7. Go to the instructions for Installing

the Bulbs, Chains, and Globe.

Removable Switch Housing

9-Pin Plug

Connector

Lower Switch

Housing

Attachment

Screw

Plug

Attachment

Screws and

Lockwashers

Wires and

Wire Nuts

9-Pin Plug

Connector

Screw

43506-01 r032907 3

Steps 4–6

Steps 1–2

Step 3

Screw

1 2 3 4 5 6

Comments to this Manuals

No comments

Hunter 22555 10 Opal Glass Schoolhouse Globe User Manual Page 3

Comments to this Manuals

Related products and manuals for Hardware Hunter 22555 10 Opal Glass Schoolhouse Globe