Hunter 21978 Installation Manual download pdf (Page 17)

41225-01 • 12/04/09 • Hunter Fan Company

Problem: Nothing happens; fan does not move.

1. Turn power on, replace fuse, or reset breaker.

2. Loosen canopy, check all connections according to the wiring the fan section.

3. Check the plug connection in the switch housing.

4. Push motor reversing switch rmly left or right to ensure that the switch is engaged.

5. Pull the pull chain to ensure it is on.

6. Remove the shipping bumpers.

Problem: Noisy operation.

1. Tighten the blade assembly screws and blade iron armature screws until snug.

2. Check to see if the blade is cracked. If so, replace all the blades.

Problem: Excessive wobbling.

1. If your fan wobbles when operating, use the enclosed balancing kit and instructions to balance the fan.

2. Tighten all blade iron screws.

3. Turn power o, support fan very carefully, and check that the hanger ball is properly seated.

In compliance with U.S. Federal regulations, this ceiling fan contains a wattage saver that limits the light

output to 190 Watts. e following issues may arise if total wattage exceeds 190 Watts:

Issue: Lights dim when turned on.

1. It is normal for the lights to dim a couple of seconds after they are turned

on. To prevent the lights from dimming, make sure the wattage of light bulbs

installed match the specications on the light sockets.

Issue: Light shuts oﬀ suddenly.

1. Turn the power to the fan o at the wall switch. Wait 30

seconds, then resume power to the fan.

2. If lights shut o suddenly again, check to make sure total

wattage of bulbs does not exceed 190 Watts.

If you need parts or service assistance, please call

888-830-1326 (In Canada, call 1-866-268-1936) or

visit us at our Web site at

http://www.hunterfan.com.

Hunter Fan Company

7130 Goodlett Farms Pkwy. #400

Memphis, Tennessee 38016

11 • Troubleshooting

1 2 ... 12 13 14 15 16 17

No comments

Hunter 21978 Installation Manual Page 17