Hunter 99107 Use and Care Manual download pdf (Page 7)

You can now reconnect power to your other fans.

Tap the Gear icon shown below.

Be sure to choose a Gear icon for a room that is not already congured.

Note: There is a maximum four rooms per Bluetooth

plug-in controller.

For further details on installing and controlling multiple fans refer to the

Information page in the app by tapping on the "i" icon.

Gear icon

Cycle power to the fan.

Turn power off and back on at the wall (or circuit breaker if necessary).

The next step must be completed WITHIN THREE MINUTES of restoring

power to the fan.

Tap OK to conrm pairing.

Note: The lights will ash (if applicable) and the fan will turn on at low

speed. This is visual conrmation that the pairing was successful.

Congratulations!

You have successfully set up your additional receiver. Tap the Back

button twice to begin using the app to take control of your fan!

setup for additional fans using a single

Bluetooth

plug-in controller

If you wish to operate multiple fans with one Bluetooth® plug-in controller:

1. You will need an additional receiver (sold separately) for each fan. Complete

the Installation section to install each receiver into your fan(s). Receivers can

be purchased at www.HunterFan.com.

2. Tap the Gear icon on the main screen to navigate to the “Rooms Congured”

settings screen.

3. Perform steps a-d on this page to complete setup.

Go to Advanced Features. Tap the Pair button.

If your bulbs support dimming, you may also

turn on the dimming feature at this screen.

To prevent faulty operation, please disconnect power from all other

ceiling fans within range while performing the next three steps.

"i" icon

1 2 3 4 5 6 7 8 9 10

No comments

Hunter 99107 Use and Care Manual Page 7