Hunter 28784 Installation Guide download pdf (Page 10)

45039-01 • 12/17/10 • Hunter Fan Company

WARNING: Failure to complete the following steps could cause the fan

to fall.

Note: It is recommended you use a magnetic tip screwdriver for the

following steps.

5-1. Rotate the hanger ball so the tab in the canopy is secure in the

hanger ball groove. Note: Your fan may have multiple tabs and

grooves that must be aligned.

5-2. Swing the fan up to align the canopy screw holes with the

mounting holes on the ceiling plate.

WARNING: e slots in the canopy must remain engaged while

swinging the canopy for alignment.

5-3. Holding the canopy up with the screw holes aligned, partially

install two canopy screws into the holes opposite the ceiling plate

tabs.

5-4. Partially install a canopy screw into the hole between the two

ceiling plate tabs.When all the holes are properly aligned, securely

tighten all three canopy screws.

5-5. Verify that the tabs in the canopy are still in the grooves of the

hanger ball.

5-6. Align the tabs on the trim ring opposite the grooves in the hanger

ball. Using both hands, push the canopy trim ring up to the top of

the canopy. e canopy trim ring will snap and lock into place.

Note: Should you need to remove the trim ring, press rmly on

opposite sides of the trim ring directly above the groove in the

hanger ball. e tabs will ex out releasing the canopy trim ring.

Step 5-1

Step 5-2

Groove

Tab

Step 5-3

Canopy Screw

Canopy

Trim

Ring

Canopy

5 • Installing the Canopy and Canopy Trim Ring

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

No comments

Hunter 28784 Installation Guide Page 10