Hunter 99158 Use and Care Manual download pdf (Page 4)

43546-01 • 07/01/10 • Hunter Fan Company

1. Unscrew the three screws from the upper switch housing. Disconnect

the 9-pin plug connectors. Remove the lower switch housing.

2. Push the plug button from inside the lower switch housing to remove

the plug button and switch housing cap.

NOTE: Save the plug button and switch housing cap should you

choose to remove the light ﬁxture in the future.

CAUTION: If your fan is operated by remote control, take care not to

damage the small components on the circuit board inside the housing.

3. Feed the two wires from the light ﬁxture through the center hole in

the lower switch housing.

4. Screw the threaded rod of the light ﬁxture into the center of the lower

switch housing until you feel resistance. Unscrew the light ﬁxture

slightly until the holes of the light ﬁxture are aligned with the holes in

the lower switch housing.

5. Finish attaching the light ﬁxture to the lower switch housing using the

two attachment screws included. Securely tighten the two screws.

6. Install the nut and washer inside the upper switch housing onto the

threaded rod from the upper light housing.

Removable Switch Housing

9-Pin Plug

Connector

Lower Switch

Housing

Plug Button

Screw

Steps 1-2

Lower

Switch

Housing

Light

Fixture

WARNING: Improper installation could cause the light ﬁxture to fall.

Steps 3-6

Washer

Nut

Attachment

Screws

Threaded

Rod

Installing the Light Kit on Fans With Removable Switch Housing

1 2 3 4 5 6 7 8 9 10

No comments

Hunter 99158 Use and Care Manual Page 4