Hunter 20593 Installation Guide download pdf (Page 6)

45072-01 • 10/21/10 • Hunter Fan Company

Note: e

isolators must be

ush against the

ceiling. A loose

ceiling mounting

plate will result

in improper

operation

of the Auto

Balance™system.

2 • Installing the Ceiling Mounting Plate (continued)

2.6

2.8

2.5

2.7

Align the slotted holes in the ceiling mounting plate (2) with the pilot

holes you drilled in the wood support structure. For proper alignment, use

slotted holes directly across from each other.

For Angled Ceilings: Be sure to orient the ceiling mounting plate (2) so

that the two tabs are pointing toward the ceiling peak as shown (left or

right view).

Unbundle the wires from the fan.

Note: Your Hunter fan comes with an optional pipe/ball assembly

extension pipe. If you are hanging the fan on a ceiling higher than 10 feet

tall and you would like to use the enclosed optional pipe/ball assembly,

follow Steps 3.9 – 3.13.

Place a at washer (68) on each of the two 3” wood screws (65). Insert

the screws into the slotted holes in the ceiling mounting plate (2) into the

pilot holes you drilled. Tighten the screws (65) into the 9/64 in. pilot holes;

do not use lubricants on the screws. Do not over tighten.

Ceiling Peak

Large

Opening

Large

Opening

LEFT

RIGHT

1 2 3 4 5 6 7 ... 23

No comments

Hunter 20593 Installation Guide Page 6